![]() ![]() If VLAN mapping is enabled on an EtherChannel and a conflicting mapping translation is enabled on a member port, the configuration If VLAN mapping is enabled on an EtherChannel, the configuration does not apply to all member ports of the EtherChannel bundleīut applies only to the EtherChannel interface. Port where One-to-One VLAN mapping is configured. S-VLAN should be created and present in the allowed VLAN list of the trunk One-to-One VLAN mapping should be identical on both ports. One-to-One VLAN mapping can be configured only on trunk ports and not on Prerequisites for One to One VLAN Mapping Or insert a BPDU filter for spanning tree, as follows: !ĭevice(config-if)# switchport vlan mapping 10 20ĭevice(config-if)# spanning-tree bpdufilter enable To process control traffic consistently, either enable Layer 2 protocol tunneling (recommended), as follows: Applicable for C9500-12Q, C9500-16X, C9500-24Q, C9500-40X models of the Cisco Catalyst 9500 Series Switches.ĭevice(config)# interface HundredGigE1/0/1ĭevice(config-if)# switchport mode accessĪpplicable for C9500-32C, C9500-32QC, C9500-48Y4C, and C9500-24Y4C models of the Cisco Catalyst 9500 Series Switches.ĭevice(config-if)# switchport vlan mapping 20 300 ![]() VLAN Mapping is supported only with the Network Advantage license level. Configuration Guidelines for VLAN Mappingīy default, no VLAN mapping is configured.Įnsure that you run the Network Advantage license.Restrictions for One to One VLAN Mapping.Prerequisites for One to One VLAN Mapping. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |